Viking specialists | San Leandro
Independent Viking refrigerator, stove, range, cooktop & oven repair in San Leandro, CA. Genuine OEM parts, clear pricing. Call (510) 390-9712 to book.
4.9/5 · 842 verified customer reviews
Salt air off San Leandro Bay quietly works on the appliances inside a kitchen. A professional Viking range, a built-in column refrigerator, a wall oven behind a custom panel — chosen by cooks who care, then asked to hold up to fog, marine damp, and daily use. We keep that Viking equipment running across San Leandro, from the flat blocks near the Marina to the hillside lots of Bay-O-Vista and Estudillo Estates.
We are an independent shop, working high-end cooking and refrigeration since 2005, and San Leandro sits inside our regular East Bay rounds — a Viking range in a Broadmoor bungalow, a column fridge in Washington Manor cabinetry, an oven off East 14th Street. We diagnose the real fault before we quote, so you hear a clear price before any work. We are not affiliated with or authorized by Viking; we simply know these platforms cold and fit genuine OEM parts to your model and serial.
Viking lines we service
Built-in and column Viking refrigerators. We work the sealed system and compressor, the evaporator and condenser fans, the defrost heater and drain, the door gasket, the air damper, and the thermistor. Matching freezer drawers and a Viking wine cabinet fall under this refrigeration work too.
Viking sealed and open-burner surfaces. We service the spark module and igniter, the surface control valves behind the VariSimmer setting, the brass burner orifices, and the porcelain-coated cast grates — restoring a clean blue flame.
Viking gas and electric ovens. We test and replace bake and broil elements, glow-bar igniters, and the RTD sensor, restore the convection fan and motor, and address door hinges and springs — then calibrate against a reference probe.
Common faults
A Viking fridge that can't hold cold usually traces to a sticking air damper, a tired evaporator fan, or a board misreading the thermistor. We confirm the sealed system and compressor are sound and replace only what failed.
Puddles near a deli drawer and frost above it point to the defrost circuit — a frozen defrost drain, a failed defrost heater, or a cracked drain pan. We clear the ice and fit a genuine part so the meltwater drains.
Persistent clicking on a Viking sealed or open burner is usually a fouled or off-center cap, a worn igniter, or a tired spark module. We clean the ports, true the cap, and fit a genuine spark module so it lights instantly.
When the simmer won't drop to a true low, the surface control valve behind that knob has worn. We fit the OEM valve and reset the brass orifice so the VariSimmer idles gently again.
Pale roasts and uneven racks point to a failing convection fan motor or a tired bake element. A cavity running hot or cold is usually a drifted RTD sensor. We fit genuine parts and calibrate against a reference probe.
Why this service
Verified reviews
Temperatures swung wildly in the Viking fridge, milk spoiling early. The tech identified a sticking air damper and a glitchy main control board. Genuine damper went in same visit; the board came a few days later. Steady cold now. Took two trips but he was upfront about that from the start.
Miles K. · San Mateo
Puddles kept forming inside my Viking fridge near the deli drawer. The tech traced it to a frozen defrost drain and a cracked drain pan. He cleared the ice, installed a genuine pan, and verified flow. Dry and cold ever since. Friendly, fast, and the price matched the quote exactly.
Kayla D. · Belmont
The simmer setting on my stove just wouldn't go low. He diagnosed a worn surface control valve and ordered the OEM part. A short wait, but once installed the VariSimmer works beautifully. Tidy work and a fair price. Would have been five stars without the delay.
Evangeline R. · Dublin
Wow, fast turnaround. My range had a burner clicking and refusing to light. The tech replaced the spark module with a genuine Viking part and cleaned the open burner ports same-day. Lights instantly now, no clicking. He even credited the diagnostic fee to the bill.
Damon T. · Walnut Creek
Strange humming and weak browning pointed to the convection system. He pulled the rear panel, found a failing convection fan motor, and dropped in a genuine Viking replacement. Roasts brown beautifully again. Showed up the same day, worked cleanly, and walked me through the whole repair. Fantastic.
Howard E. · Sonoma
Visible FAQ
No. We are an independent repair company that has worked high-end appliances since 2005. We are not affiliated with or authorized by Viking, and we never claim to be. We use genuine Viking OEM parts and know these refrigerators, ranges, and ovens cold.
Usually the burner cap has shifted off-center or fouled, the igniter has worn, or the spark module is failing — and San Leandro's marine damp can worsen it by bridging the spark gap. We clean and true the cap, clear the ports, and fit a genuine Viking part.
It depends on the part — an igniter or RTD sensor is modest, a sealed-system or main-board repair sits higher. Our diagnostic fee is $89 and you hear a clear price before any work. We can often offer a same-week window; call (510) 390-9712 to book.
Yes — the Marina flats, Broadmoor, Washington Manor, the Bal neighborhood off East 14th Street, and the hillside lots of Bay-O-Vista and Estudillo Estates. We plan arrival around the climbing, parking-tight hill streets.
San Leandro Sub-Zero Repair is an independent appliance repair company — not affiliated with or authorized by Viking, and not a manufacturer-authorized service center. Viking is a trademark of its owner, used here only to describe the appliances we service. Other brands: Sub-Zero repair and Wolf appliance repair.
A clear price before any work
For a fridge that won't hold cold or a burner that won't light, call with your model number for the fastest window.
